Phillips & Temro Wolverine PAD Heater Electric 4 x 4" 125w 12v (CE)

3400052 Wolverine Silicone PAD Heater Electric 4 x 4" 125w 12v

Adhesive Silicone Pad Heaters for Engine Oil, Transmission Fluid, Reservoir and Hydraulic Fluid.

Operating in extreme conditions requires dependable solutions. Give your engine the help it needs to start in the coldest weather by installing silicone pad heaters. These heaters are designed to provide warmth to areas with fluid susceptible to freezing or thickening. Electric heating pads are designed to be applied directly to the source, resulting in direct heat transfer. They are a low wattage, energy efficient solution.

The wires are not polarity sensitive and so can be wired either way around.

CALCULATING FUSE SIZE: To calculate the correct fuse size it is recommended to add up the continuous current draw of all connected loads, multiply by 150% (x1.5) and then round up to the next available fuse size. For a heater with a 10a continuous current draw we would calculate: 10 x 1.5 = 15, the closest fuse size equal to or rounded up would be 15a. Please ensure the fuses are installed as close to the battery as possible.

CALCULATING CABLE SIZE: To determine your cable size it is recommended to choose a cable with a higher rated capacity than your calculated fuse, this will ensure that the fuse will blow before your wiring gets hot and potentially catches fire. From our example above, we would choose a cable size with a nominal current rating of at least 20a.

The Silicone PAD Heater kit comes with the following components:

ATTENTION

• Attach heater to metal surface only! Surface must be flat and smooth, with no bumps, ridges, or grooves. Surface must be warmed to >100°F (38°C). Do not use additional adhesives to secure heater.
• Please double check dimensions and voltage are suitable for your application prior to checkout.